1 The top piece can easily be removed
from the main piece (use the finger grips).
If the top piece is difficult to remove,
leave on the aspirator tube as shown
- then there is more to hold on to.
2 Turn of easily the aspirator tube while
using the finger grip.
3 The bottom piece can easily
be removed from the main piece
in order to clean the different parts.
You may use a brush or a dishwasher
up to 95° Celsius. After this, the adjuster
and the O-ring should be lubricated with
silicone grease or Vaseline.
4 Assemble the adjuster into
the main piece and all parts
can now be assembled by a
slight pressure. Make sure
the adjuster slides easily in
the main piece. The handpieces
can tolerate autoclaving up
to 135° Celsius.
5 The handpiece is now ready to be
used! When reassembling the hand-
piece with the existing suction hose,
it might be necessary to cut off
approximately 3 cm of the suction hose
in order to obtain maximum connection.